Reference Guide

190 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
Related
Commands
set next-hop
s z
Configure a filter to specify an IP address as the next hop.
Syntax
set next-hop ip-address
To delete the setting, use the no set next-hop ip-address command.
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
Usage
Information
If the set next-hop command is configured, its configuration takes precedence over the neighbor
next-hop-self (S-Series) command in the ROUTER BGP mode.
If you configure the set next-hop command with the interface’s (either Loopback or physical) IP
address, the software declares the route unreachable.
Related
Commands
Version 9.0.2.0 Introduced on the S6000
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.1.0
Implemented
internal keyword
Version 7.6.1.0 Support added for S-Series
set automatic-tag Compute the tag value of the route.
set level Specify the OSPF area for route redistribution.
set metric Specify the metric value assigned to redistributed routes.
set tag Specify the tag assigned to redistributed routes.
S6000
ip-address
Specify an IP address in dotted decimal format.
Version 9.0.2.0 Introduced on the S6000
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Support added for S-Series
match ip next-hop Redistribute routes that match the next-hop IP address.
neighbor next-hop-self
(S-Series)
Configure the routers as the next hop for a BGP neighbor.