Reference Guide

186 | Access Control Lists (ACL)
www.dell.com | support.dell.com
To return to the default, enter no set automatic-tag.
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
Related
Commands
set comm-list delete
s z
Configure a filter to remove the specified community list from the BGP route’s COMMUNITY
attribute.
Syntax
set comm-list community-list-name delete
To insert the community list into the COMMUNITY attribute, use the no set comm-list
community-list-name delete command.
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
Usage
Information
The community list used in the set comm-list delete command must be configured so that each
filter contains only one community. For example, the filter deny 100:12 is acceptable, but the
filter deny 120:13 140:33 results in an error.
If the set comm-list delete command and the set community command are configured in the
same route map sequence, then the deletion command (set comm-list delete) is processed before
the insertion command (set community).
Prior to 7.8.1.0, names are up to 16 characters long.
Version 9.0.2.0 Introduced on the S6000
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Support added for S-Series
set level Specify the OSPF area for route redistribution.
set metric Specify the metric value assigned to redistributed routes.
set metric-type Specify the metric type assigned to redistributed routes.
set tag Specify the tag assigned to redistributed routes.
S6000
community-list-name
Enter the name of an established Community list, up to 140 characters.
Version 9.0.2.0 Introduced on the S6000
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to
16 characters long.
Version 7.6.1.0 Support added for S-Series