Reference Guide

Access Control Lists (ACL) | 183
Command
History
match route-type
s z
Configure a filter to match routes based on the how the route is defined.
Syntax
match route-type {external [type-1 | type-2] | internal | level-1 | level-2 | local}
To delete a match, use the no match route-type {local | internal | external [type-1 | type-2] |
level-1 | level-2} command.
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
Related
Commands
match tag
s z
Configure a filter to redistribute only routes that match a specified tag value.
Syntax
match tag tag-value
To remove a match, use the no match tag command.
Version 9.0.2.0 Introduced on the S6000
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Support added for S-Series
S6000
external [type-1| type-2] Enter the keyword external followed by either type-1 or type-2 to
match only on OSPF Type 1 routes or OSPF Type 2 routes.
internal Enter the keyword internal to match only on routes generated within
OSPF areas.
level-1 Enter the keyword level-1 to match IS-IS Level 1 routes.
level-2 Enter the keyword level-2 to match IS-IS Level 2 routes.
local Enter the keyword local to match only on routes generated within the
switch.
Version 9.0.2.0 Introduced on the S6000
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Support added for S-Series
match interface Redistribute routes that match the next-hop interface.
match ip address Redistribute routes that match an IP address.
match ip next-hop Redistribute routes that match the next-hop IP address.
match ip route-source Redistribute routes that match routes advertised by other routers.
match metric Redistribute routes that match a specific metric.
match tag Redistribute routes that match a tag.
S6000