Reference Guide

Access Control Lists (ACL) | 179
match community
s z
Configure a filter to match routes that have a certain COMMUNITY attribute in their BGP path.
Syntax
match community community-list-name [exact]
To delete a community match filter, use the no match community command.
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
Related
Commands
match interface
s z
Configure a filter to match routes whose next hop is on the interface specified.
Syntax
match interface interface
To remove a match, use the no match interface interface command.
Parameters
Defaults
Not configured
Command Modes
ROUTE-MAP
S6000
community-list-name
Enter the name of a configured community list.
exact (OPTIONAL) Enter the keywords exact to process only those routes with this
community list name.
Version 9.0.2.0 Introduced on the S6000
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Support added for S-Series
set community Specify a COMMUNITY attribute.
neighbor send-community Send COMMUNITY attribute to peer or peer group.
S6000
interface
Enter the following keywords and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the slot/port
information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/
port information.
• For the loopback interface, enter the keyword
loopback followed by a number from zero (0)
to 16383.
• For a Port Channel interface, enter the keyword
port-channel followed by a number:
S-Series Range: 1-128
• For a Ten Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by
the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number from 1 to 4094, 1-2094 for
ExaScale (can used IDs 1-4094).
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port
information.