Reference Guide

176 | Access Control Lists (ACL)
www.dell.com | support.dell.com
QoS Optimization for IPv6 ACLs does not impact the CAM usage for applying a policy on a single (or
the first of several) interfaces. It is most useful when a policy is applied across multiple interfaces; it
can reduce the impact to CAM usage across subsequent interfaces.
Route Map Commands
When an access-list is created without any rule and then applied to an interface, ACL behavior reflects
implicit permit.
The following commands allow you to configure route maps and their redistribution criteria.
• continue
• description
• match as-path
• match community
• match interface
• match ip address
• match ip next-hop
• match ip route-source
• match metric
• match origin
• match route-type
• match tag
• route-map
• set as-path
• set automatic-tag
• set comm-list delete
• set community
• set level
• set local-preference
• set metric
• set metric-type
• set next-hop
• set origin
• set tag
• set weight
• show config
• show route-map
continue
s z
Configure a route-map to go to a route-map entry with a higher sequence number.
Syntax
continue [sequence-number]
To remove the continue clause, use the no continue [sequence-number] command.
S6000