Reference Guide

168 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Defaults
Not configured.
Command Modes
ACCESS-LIST
Command
History
Usage
Information
Most ACL rules require one entry in the CAM. However, rules with TCP and UDP port operators (gt,
lt
, range) may require more than one entry. The range of ports is configured in the CAM based on
bitmask boundaries; the space required depends on exactly what ports are included in the range.
For example, an ACL rule with TCP port range 4000 - 8000 uses 8 entries in the CAM:
Rule# Data Mask From To #Covered
1 0000111110100000 1111111111100000 4000 4031 32
2 0000111111000000 1111111111000000 4032 4095 64
3 0001000000000000 1111100000000000 4096 6143 2048
4 0001100000000000 1111110000000000 6144 7167 1024
5 0001110000000000 1111111000000000 7168 7679 512
6 0001111000000000 1111111100000000 7680 7935 256
7 0001111100000000 1111111111000000 7936 7999 64
8 0001111101000000 1111111111111111 8000 8000 1
Total Ports: 4001
But an ACL rule with TCP port lt 1023 takes only one entry in the CAM:
Rule# Data Mask From To #Covered
1 0000000000000000 1111110000000000 0 1023 1024
Total Ports: 1024
Related
Commands
remark
s
Enter a description for an IPv6 ACL entry.
Syntax
remark remark number [description]
To delete the description, use the no remark remark number command (it is not necessary to include
the remark description that you are deleting).
Parameters
Defaults
Not configured
count (OPTIONAL) Enter the keyword count to count packets processed by the
filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by the filter.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.7.0
Introduced on the S4810.
permit Assign a permit filter for IP packets.
permit tcp Assign a permit filter for TCP packets.
S6000
remark number
Enter the remark number. Note that the same sequence number can be used
for the remark and an ACL rule.
Range: 0 to 4294967290
description
Enter a description of up to 80 characters.