Reference Guide

Access Control Lists (ACL) | 163
Command
History
Usage
Information
You can assign an IPv6 access group to a physical, LAG, or VLAN interface context.
Example
Figure 6-13. Command Example: ipv6 access-group
FTOS(conf-if-gi-9/0)#ipv6 access-group AclList1 in implicit-permit vlan 10-20
FTOS(conf-if-gi-9/0)#show config
!
interface GigabitEthernet 9/0
no ip address
ipv6 access-group AclList1 in implicit-permit Vlan 10-20
no shutdown
FTOSconf-if-gi-9/0)#
ipv6 access-list
s
Configure an access list based on IPv6 addresses or protocols.
Syntax
ipv6 access-list access-list-name
To delete an access list, use the no ipv6 access-list access-list-name command.
Parameters
Defaults
All access lists contain an implicit “deny any”; that is, if no match occurs, the packet is dropped.
Command Modes
CONFIGURATION
Command
History
Usage
Information
The number of entries allowed per ACL is hardware-dependent. Refer to your stack-unit
documentation for detailed specification on entries allowed per ACL.
Related
Commands
ipv6 control-plane egress-filter
s
Enable egress Layer 3 ACL lookup for IPv6 CPU traffic.
Syntax
ipv6 control-plane egress-filter
Defaults
Not enabled
Command Modes
EXEC Privilege
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.7.0
Introduced on the S4810.
S6000
access-list-name
Enter the as the access list name as a string, up to 140 characters.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.7.0
Introduced on the S4810.
show config View the current configuration.
S6000