Reference Guide

Access Control Lists (ACL) | 157
Parameters
Command Modes
CONFIGURATION
Command
History
Usage
Information
You must save the new CAM settings to the startup-config (write-mem or copy run start) then reload
the system for the new settings to take effect.
The total amount of space allowed is 4 FP Blocks.
Example
Figure 6-12. Command Example: cam-acl-egress
FTOS#
FTOS#configure
FTOS(conf)#cam-acl-egress ?
default Reset Egress CAM ACL entries to default setting
l2acl Set L2-ACL entries
FTOS(conf)#cam-acl-egress l2acl ?
<1-4> Number of FP blocks for l2acl
FTOS(conf)#cam-acl-egress l2acl 1 ?
ipv4acl Set IPV4-ACL entries
FTOS(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ?
ipv6acl Set IPV6-ACL entries
FTOS(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl ?
<0-4> Number of FP blocks for IPV6 (multiples of 2)
FTOS(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl 2
clear counters ipv6 access-group
s
Erase all counters maintained for the IPv6 access lists.
Syntax
clear counters ipv6 access-group [access-list-name]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
default
Use the default CAM profile settings, and set the CAM as follows.
L2 ACL(l2acl): 1
L3 ACL (ipv4acl): 1
IPv6 L3 ACL (ipv6acl): 2
l2acl 1-4 ipv4acl 1- 4 ipv6acl
0-4
Allocate space to support IPv6 ACLs. You must enter all of the profiles
and a range for each.
Enter the CAM profile name followed by the amount to be allotted.
The total space allocated must equal 4.
The
ipv6acl range must be a factor of 2.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.7.0
Introduced on the S4810.
S6000
access-list-name
(OPTIONAL) Enter the name of a configured access-list, up to 140 characters.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.7.0
Introduced on the S4810.