Reference Guide

150 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Related
Commands
IP Prefix List Commands
When an access-list is created without any rule and then applied to an interface, ACL behavior reflects
implicit permit.
Use these commands to configure or enable IP prefix lists.
• clear ip prefix-list
• deny
• ip prefix-list
• permit
• seq
• show config
• show ip prefix-list detail
• show ip prefix-list summary
clear ip prefix-list
s z
Reset the number of times traffic met the conditions (“hit” counters) of the configured prefix lists.
Syntax
clear ip prefix-list [prefix-name]
Parameters
Command Modes
EXEC Privilege
Command
History
Default
Clears “hit” counters for all prefix lists unless a prefix list is specified.
Related
Commands
Version 8.3.11.1 Introduced on the Z9000.
Version 9.0.2.0 Support added for S-Series
Note: When ACL logging and byte counters are configured simultaneously, byte counters
may display an incorrect value. Configure packet counters with logging instead.
deny Configure a filter to drop traffic.
permit Configure a filter to forward traffic.
S6000
prefix-name
(OPTIONAL) Enter the name of the configured prefix list to clear only counters for that
prefix list, up to 140 characters long.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to
16 characters long.
Version 7.6.1.0 Support added for S-Series
Version 9.0.2.0 Introduced on the S6000
ip prefix-list Configure a prefix list.