Reference Guide

140 | Access Control Lists (ACL)
www.dell.com | support.dell.com
mac access-group
s z
Apply a MAC ACL to traffic entering or exiting an interface.
Syntax
mac access-group access-list-name {in [vlan vlan-range] | out}
To delete a MAC access-group, use the no mac access-group mac-list-name command.
Parameters
Defaults
No default behavior or configuration
Command Modes
INTERFACE
Command
History
Usage
Information
You can assign one ACL (standard or extended) to an interface.
Prior to 7.8.1.0, names are up to 16 characters long.
Related
Commands
show mac accounting access-list
s z
Display MAC access list configurations and counters (if configured).
Syntax
show mac accounting access-list access-list-name interface interface in | out
S6000
access-list-name
Enter the name of a configured MAC access list, up to 140 characters.
vlan vlan-range
(OPTIONAL) Enter the keyword vlan followed a range of VLANs. Note that this
option is available only with the
in keyword option.
Range: 1 to 4094, 1-2094 for ExaScale (can used IDs 1-4094)
in Enter the keyword in to configure the ACL to filter incoming traffic.
out Enter the keyword out to configure the ACL to filter outgoing traffic. Not
available on S-Series.
Version 9.0.2.0 Introduced on the S6000
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to
16 characters long.
Version 9.0.2.0 Support added for S-Series
mac access-list standard Configure a standard MAC ACL.
mac access-list extended Configure an extended MAC ACL.
S6000