Reference Guide

112 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Parameters
Defaults
Not enabled.
Command Modes
CONFIGURATION-STANDARD-ACCESS-LIST
CONFIGURATION-EXTENDED-ACCESS-LIST
CONFIGURATION-MAC ACCESS LIST-STANDARD
CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
History
remark
s z
Enter a description for an ACL entry.
Syntax
remark [remark-number] [description]
To delete the description, use the no remark [remark number] command. Note that it is not
necessary to include the remark description that you are deleting.
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION-STANDARD-ACCESS-LIST
CONFIGURATION-EXTENDED-ACCESS-LIST
CONFIGURATION-MAC ACCESS LIST-STANDARD
CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
History
Usage
Information
The remark command is available in each ACL mode. You can configure up to 4294967290 remarks
in a given ACL.
The following example shows the use of the remark command twice within the
CONFIGURATION-STANDARD-ACCESS-LIST mode. Here, the same sequence number was used
for the remark and for an associated ACL rule. The remark will precede the rule in the running-config
because it is assumed that the remark is for the rule with the same sequence number, or the group of
rules that follow the remark.
text
Enter a text string up to 80 characters long.
Version 9.0.2.0 Introduced on S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on S-Series.
S6000
remark-number
Enter the remark number. Note that the same sequence number can be used
for the remark and an ACL rule.
Range: 0 to 4294967290
description
Enter a description of up to 80 characters.
Version 9.0.2.0 Introduced on S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on S-Series.