Reference Guide

108 | 802.1X
www.dell.com | support.dell.com
show dot1x interface
s
Display the 802.1X configuration of an interface.
Syntax
show dot1x interface interface [mac-address mac-address]
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
EXEC privilege
Command
History
Usage
Information
S-Series : Enter a supplicant’s MAC address using the mac-address option to display
information only on the 802.1X-enabled port to which the supplicant is connected.
If 802.1X multi-supplicant authentication is enabled on a port, additional 802.1X
configuration details (port authentication status, untagged VLAN ID, authentication
PAE state, and backend state) are displayed for each supplicant as shown in the last
example.
Example
FTOS#show dot1x int Gi 2/32
802.1x information on Gi 2/32:
-----------------------------
Dot1x Status: Enable
Port Control: AUTO
Port Auth Status: UNAUTHORIZED
Re-Authentication: Disable
Untagged VLAN id: None
Guest VLAN: Enable
Guest VLAN id: 10
Auth-Fail VLAN: Enable
Auth-Fail VLAN id: 11
Auth-Fail Max-Attempts: 3
Tx Period: 30 seconds
Quiet Period: 60 seconds
S6000
interface Enter one of the following keywords and slot/port or number information:
• For a Gigabit Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For a Fast Ethernet interface, enter the keyword FastEthernet followed by
the slot/port information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
mac-address (Optional) MAC address of a supplicant.
Version 9.0.2.0 Introduced on S6000
Version 8.3.12.0 Introduced on the S4810.
Version 8.4.1.0 Introduced on S-Series