Reference Guide

802.1X | 107
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
EXEC privilege
Command
History
Usage
Information
Enter a supplicant’s MAC address using the mac-address option to display CoS
mapping information only for the specified supplicant.
You can display the CoS mapping information applied to traffic from authenticated
supplicants on 802.1X-enabled ports that are in single-host, multi-host, and
multi-supplicant authentication modes.
Example
FTOS#show dot1x cos-mapping interface gigabitethernet 2/21
802.1p CoS re-map table on Gi 2/21:
----------------------------------
Dot1p Remapped Dot1p
0 7
1 6
2 5
3 4
4 3
5 2
6 1
7 0
FTOS#show dot1x cos-mapping int g 2/21 mac-address 00:00:01:00:07:00
802.1p CoS re-map table on Gi 2/21:
----------------------------------
802.1p CoS re-map table for Supplicant: 00:00:01:00:07:00
Dot1p Remapped Dot1p
0 7
1 6
2 5
3 4
4 3
5 2
6 1
7 0
interface Enter one of the following keywords and slot/port or number information:
• For a Gigabit Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For a Fast Ethernet interface, enter the keyword FastEthernet followed by
the slot/port information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
mac-address (Optional) MAC address of an 802.1X-authenticated supplicant.
Version 9.0.2.0 Introduced on S6000
Version 8.3.12.0 Introduced on the S4810.
Version 8.4.1.0 Introduced on S-Series