Concept Guide

Displaying Information about a Stack
To display information about the stack, use the following command.
• Display for stack-identity, status, and hardware information on every unit in a stack.
EXEC Privilege mode
show system
• Display most of the information in show system, but in a more convenient tabular form.
EXEC Privilege mode
show system brief
• Display the same information in show system, but only for the specied unit.
EXEC Privilege mode
show system stack-unit
• Display topology and stack link status for the entire stack.
EXEC Privilege mode
show system stack-ports [status | topology]
Examples of the show system Commands
Display information about a switch stack using the show system command.
The following is an example of the show system command to view the stack details.
DellEMC#show system
Stack MAC : 90:b1:1c:f4:a7:c7
Reload-Type : normal-reload [Next boot : normal-reload]
-- Unit 2 --
Unit Type : Standby Unit
Status : online
Next Boot : online
Required Type : S6000 - 32-port TE/FG (SI)
Current Type : S6000 - 32-port TE/FG (SI)
Master priority : 1
Hardware Rev : 4.0
Num Ports : 128
Up Time : 4 hr, 25 min
Dell Networking OS Version : 1-0(0-3387)
Jumbo Capable : yes
POE Capable : no
FIPS Mode : disabled
Burned In MAC : 90:b1:1c:f4:9b:88
No Of MACs : 3
-- Power Supplies --
Unit Bay Status Type FanStatus FanSpeed(rpm)
------------------------------------------------------------
2 0 up AC up 6656
2 1 up AC up 6688
-- Fan Status --
Unit Bay TrayStatus Fan0 Speed Fan1 Speed
------------------------------------------------------------
2 0 up up 7021 up 7072
2 1 up up 7021 up 7072
2 2 up up 7021 up 7021
946
Stacking