Concept Guide

aggregated to form the committed burst size. Trac is considered to be green-colored up to the point at which the unused bandwidth
does not exceed the committed burst size.
Peak rate refers to the maximum rate for trac arriving or exiting an interface under normal trac conditions. Peak burst size indicates the
maximum size of unused peak bandwidth that is aggregated. This aggregated bandwidth enables brief durations of burst trac that
exceeds the peak rate and committed burst.
In releases of Dell EMC Networking OS earlier than Release 9.3(0.0), you can congure only the maximum shaping attributes, such as the
peak rate and the peak burst settings. You can now specify the committed or minimum burst and committed rate attributes. The
committed burst and committed rate values can be dened either in bytes or pps.
You can use the rate-shape pps peak-rate burst-packets command in the QoS Policy Out Conguration mode to congure
the peak rate and burst size as a measure of pps. Alternatively, you can use the rate shape kbps peak-rate burst-KB command
to congure the peak rate and peak burst size as a measure of bytes.
Similarly, you can use the rate-shape pps peak-rate burst-packets committed pps committed-rate burst-
packets command in the QoS Policy Out Conguration mode to congure the committed rate and committed burst size as a measure of
pps. Alternatively, you can use the rate shape kbps peak-rate burst-KB committed kbps committed-rate burst-
KB command to congure the committed rate and committed burst size as a measure of bytes. If you congure the peak rate in pps, the
peak burst size must also be congured as a measure of number of packets. Similarly, if you congure the peak rate in Kbps, the peak burst
size must also be congured as a measure of bytes.
Conguring Policy-Based Rate Shaping
You can congure the rate shaping for QoS output policies in packets per second (pps).
You can explicitly specify the rate shaping functionality for QoS output policies as peak rate and committed rate attributes. You can also
congure the peak burst and committed burst sizes. All of these settings can be congured in Kbps, Mbps, or pps.
To congure the peak and committed rates and burst sizes, perform the following steps:
1 Congure the peak rate and peak burst size in pps in QoS Policy Out Conguration mode.
QOS-POLICY-OUT mode
DellEMC(config-qos-policy-out)# rate shape pps peak-rate burst-packets
2 Alternatively, congure the peak rate and peak burst size in bytes.
QOS-POLICY-OUT mode
DellEMC(config-qos-policy-out)# rate shape Kbps peak-rate burst-KB
3 Congure the committed rate and committed burst size in pps.
QOS-POLICY-OUT mode
DellEMC(config-qos-policy-out)# rate shape pps peak-rate burst-packets committed pps
committed-rate burst-packets
4 Alternatively, congure the committed rate and committed burst size in bytes.
QOS-POLICY-OUT mode
DellEMC(config-qos-policy-out)# rate shape Kbps peak-rate burst-KB committed Kbps committed-
rate burst-KB
760
Quality of Service (QoS)