Administrator Guide

spanning-tree
Enable the multiple spanning tree protocol on the interface.
S6000
Syntax
spanning-tree
To disable the multiple spanning tree protocol on the interface, use the no spanning-tree command.
Parameters
spanning-tree Enter the keywords spanning-tree to enable the MSTP on the interface.
Defaults Enable.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.0 Introduced on the E-Series.
spanning-tree msti
Configure multiple spanning tree instance cost and priority for an interface.
S6000
Syntax
spanning-tree msti instance {cost cost | priority priority}
Parameters
msti instance Enter the keyword msti and the MST instance number. The range is from zero (0) to 63.
cost cost (OPTIONAL) Enter the keyword cost then the port cost value. The range is from 1 to
200000. The defaults are:
• 100 Mb/s Ethernet interface = 200000
Multiple Spanning Tree Protocol (MSTP) 953