Administrator Guide

Lines
Beginning With
Description
1 Route
Processor...
Hardware configuration of the system, including the number and type of physical
interfaces available
Example (S6000)
DellEMC# show version
Dell Real Time Operating System Software
Dell Operating System Version: 2.0
Dell Application Software Version: 9-4(0-119)
Copyright (c) 1999-2014 by Dell Inc. All Rights Reserved.
Build Time: Tue Mar 18 10:32:02 PDT 2014
Build Path: /work.local/build/buildSpaces/build01/E9-4-0/SW/SRCC
Dell EMC Networking OS uptime is 1 day(s), 0 hour(s), 19 minute(s)
System image file is "DT-MAA-S6000-16-PI"
System Type: S6000
Control Processor: Intel Centerton with 3203911680 bytes of memory, core(s)
2.
16G bytes of boot flash memory.
1 32-port TE/FG (SI)
32 Forty GigabitEthernet/IEEE 802.3 interface(s)
DellEMC#
upgrade boot
Upgrade the bootflash image or bootselector image.
S6000
Syntax
upgrade boot {all | bootflash—image | bootselector-image}stack-unit {stack—unit
—id | all}{booted | flash: | ftp: | scp: | tftp: | usbflash:}
Parameters
all Enter the keyword all to change both the bootflash and bootselector images.
bootflash-image Enter the keyword bootflash-image to change the bootflash image..
bootselector-
image
Enter the keyword bootselector-image to upgrade the BIOS system image.
stack-unit-id Enter the stack–unit–id to upgrade only the mentioned stack-unit .
all Enter the keywords all to upgrade the member stack-units.
booted Enter the keyword booted to upgrade from the current image on the device.
ftp: Enter the keyword ftp to follow it with the location of the source file in this form: //
userid:password@hostip/filepath, or press Enter to launch a prompt sequence.
tftp: Enter the keyword tftp to follow it with the location of the source file in this form: //
hostlocation/filepath, or press Enter to launch a prompt sequence.
flash: Enter the keyword flash to follow it with the location of the source file in this form: //
filepath, or press Enter to launch a prompt sequence.
usbflash: Enter the keyword flash to follow it with the location of the source file in this form: //
filepath, or press Enter to launch a prompt sequence.
A: Enter the keyword A to upgrade the bootflash partition A:.
B: Enter the keyword B to upgrade the bootflash partition B:.
Defaults none
Command Modes EXEC Privilege
78 File Management