Administrator Guide

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Example
DellEMC# show ip route list test
Codes:C- connected, S - static, R - RIP,
B- BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O- OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2- OSPF NSSA external type 2, E1 - OSPF external type 1,
E2- OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2- IS-IS level-2, IA - IS-IS inter area, * - candidate default,
>- non-active route, + - summary route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
R 2.1.0.0/24 via 2.1.4.1, Te 4/43 120/2 3d0h
R 2.1.1.0/24 via 2.1.4.1, Te 4/43 120/2 3d1h
R 2.1.2.0/24 via 2.1.4.1, Te 4/43 120/1 3d0h
R 2.1.3.0/24 via 2.1.4.1, Te 4/43 120/1 3d1h
C 2.1.4.0/24 Direct, Te 4/43 0/0 3d1h
Related
Commands
• ip prefix-list — enter CONFIGURATION-IP PREFIX-LIST mode and configures a prefix list.
• show ip prefix-list summary — display a summary of the configured prefix lists.
show ip route summary
View a table summarizing the IP routes in the switch.
S6000
Syntax
show ip route [vrf vrf-name] [summary]
Parameters
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to view information on the IP
routes corresponding to that VRF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
IPv4 Routing 771