Administrator Guide
Version Description
9.10(0.0) Introduced on the S3100 series, S4048–ON, S4048–ON, S4810, S4820T, S5000, S6000,
S6000–ON, S6100–ON, the Configuration Terminal Batch mode on C9010, Z9100–ON,
and Z9500.
9.9(0.0) Introduced on the C9010.
Usage Information
The dot1x profile command configures a dot1x profile to define a list of trusted supplicant MAC addresses.
Maximum number of dot1x profiles is limited to 10. This command launches dot1x profile mode for entering profile
related commands such as the
mac command. The dot1x static-mab command assigns the dot1x profile to
an interface.
Use this command in Configuration Terminal Batch mode to configure the dot1x profile in a dual-homing setup.
Related
Commands
• dot1x static-mab
• mac
dot1x static-mab
Enable static MAC authorization bypass (MAB) and configure static MAB profile to an interface.
Syntax
[no] dot1x static-mab profile profile-name
Parameters
profile
profile-
name
Enter the keyword profile and the profile-name to configure the static MAB profile
name. The profile name length is limited to 32 characters.
Defaults Disabled.
Command Modes
INTERFACE
INTERFACE (BATCH MODE)
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S3100 series, S4048–ON, S4048–ON, S4810, S4820T, S5000, S6000,
S6000–ON, S6100–ON, the Configuration Terminal Batch mode on C9010, Z9100–ON,
and Z9500.
9.9(0.0) Introduced on the C9010.
Usage Information
The dot1x static-mab command enables static MAB (mac auth bypass) and configures the associated
profile on a dot1x interface. Static MAB bypasses the authentication server for the supplicant MAC addresses
configured in the associated profile.
Before you enable static MAB, you must do the following:
• Enable MAC authentication bypass on the port by configuring the dot1x mac-auth-bypass command.
• Ensure that no configured profile exists at the time of configuring the static-mab command.
• Use this command in Interface Batch Mode to enable static MAB in a dual-homing setup.
Example
DellEMC(conf)#do show dot1x interface twentyFiveGigE 1/41
802.1x information on Tf 1/41:
----------------------------------------
Dot1x Status: Enable
Port Control: AUTO
Port Auth Status: AUTHORIZED (STATIC-MAB)
Re-Authentication: Enable
Untagged VLAN id: 400
Guest VLAN: Enable
Guest VLAN id: 400
160 802.1X