Administrator Guide
If you have enabled IPsec authentication in an OSPFv3 area with the area authentication command, you
cannot use the area encryption command in the area at the same time.
The configuration of IPsec encryption on an interface-level takes precedence over an area-level configuration. If
you remove an interface configuration, an area encryption policy that has been configured is applied to the
interface.
To remove an IPsec encryption policy from an interface, enter the no area area-id encryption spi number
command.
Related
Commands
• ipv6 ospf encryption – configure an IPsec encryption policy on an OSPFv3 interface.
• show crypto ipsec policy – display the configuration of IPsec encryption policies.
area nssa
Specify an area as a not so stubby area (NSSA).
Syntax
area area-id nssa [default-information-originate] [no-redistribution] [no-
summary]
To delete an NSSA, use the no area area-id nssa command.
Parameters
area-id
Specify the OSPF area by entering a number from zero (0) to 65535.
no-redistribution (OPTIONAL) Specify that the redistribute command does not distribute routes into
the NSSA. This command can be used when the router is an autonomous system
boundary router (ASBR) or area border router (ABR).
default-
information-
originate
(OPTIONAL) Allows external routing information to be imported into the NSSA by using
Type 7 default.
no-summary (OPTIONAL) Specify that no summary LSAs should be sent into the NSSA.
Defaults Not configured.
Command Modes ROUTER OSPF
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.13(0.0) Introduced on the remaining DNOS platforms.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for the Multi-Process OSPF.
1078 Open Shortest Path First (OSPFv2 and OSPFv3)