Reference Guide

BLK HOLE 0 0
Dell>
Related
Commands
clear ip fib stack-unit — clear FIB entries on a specified stack-unit.
show ip flow
Show how a Layer 3 packet is forwarded when it arrives at a particular interface.
S6000
Syntax
show ip flow interface interface {source-ip address
destination-ip address} {protocol number [tcp | udp]} {src-port
number destination-port number}
Parameters
interface
interface
Enter the keyword interface then one of the following
interface keywords.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
source-ip
address
Enter the keywords source-ip then the IP source address
in IP address format.
destination-ip
address
Enter the keywords destination-ip then the IP
destination address in IP address format.
protocol
number [tcp |
udp]
Enter the keyword protocol then one of the protocol type
keywords: tcp, udp, or protocol number The protocol
number range is from 0 to 255. .
src-port
number
Enter the keywords src-port then the source port number.
destination-
port number
Enter the keywords destination-port then the destination
port number.
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
754
IPv4 Routing