Reference Guide

Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
Enabling RSA authentication allows the user to log in without being prompted for a
password. In addition, the OpenSSH compatible SSHv2 RSA public key must be
added to the list of authorized keys (ip ssh rsa-authentication my-
authorized-keys device://filename command).
ip ssh server
Configure an SSH server. SSH server is enabled by default.
S6000
Syntax
NOTE: Some of the parameters in this command require licensing to access.
For more information, contact your Dell Networking representative.
ip ssh server {ciphers cipher-list} {enable | port port-number}
[kex key-exchange-algorithm] [mac hmac-algorithm] [version {1 |
2}]
To disable SSH server functions, use the no ip ssh server {ciphers
cipher-list} {enable | port port-number} [kex key-exchange-
algorithm] [mac hmac-algorithm] [version {1 | 2}] command.
Parameters
enable Enter the key word enable to start the SSH server.
ciphers cipher-
list
Enter the keyword ciphers and then a space-delimited list
of ciphers that the SSH server supports.
The following ciphers are available.
1290
Security