Reference Guide

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.1.9.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 6.2.1.1 Introduced on the E-Series.
Usage
Information
The unit of bandwidth percentage is 1%. If the sum of the bandwidth percentages
given to all eight classes exceeds 100%, the bandwidth percentage automatically
scales down to 100%.
Related
Commands
qos-policy-output — creates a QoS output policy.
buffer-stats-snapshot
Enable the buffer statistics tracking utility and enter the Buffer Statistics Snapshot configuration mode.
You must enable this utility to be able to configure the parameters for buffer statistics tracking. This utility
is supported on the S6000 platform.
S6000
Syntax
[No] buffer-stats-snapshot
To disable the buffer statistics tracking utility, enter the disable command from
the BUFFER-STATS-SNAPSHOT mode.
Default By default, buffer statistics tracking is disabled.
Command
Modes
CONFIGURATION mode
Command
History
Version 9.3.0.0 Introduced on the S6000 platform
Usage
Information
Only the software-based trigger for retrieving and calculating the snapshots of the
statistical counters of the buffer space is supported. Collection of snapshots of
buffer statistical counters based on hardware threshold settings is not supported,
which can be used to specify the type of hardware threshold and the threshold
profile templates.
Example
Dell(conf)#buffer-stats-snapshot
Dell(conf-buffer-stats-snapshot)#?
disable Disable buffer-stats-snapshot globally
end Exit from configuration mode
exit Exit from buffer-stats-snapshot
configuration mode
Quality of Service (QoS)
1115