Reference Guide

Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Related
Commands
service-class dot1p-mapping — Identifies the class map.
strict-priority queue
Configure a unicast queue as a strict-priority (SP) queue.
S6000
Syntax
strict-priority queue unicast number
Parameters
unicast number Enter the keyword unicast then the queue number. The
range is from 1 to 3.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Usage
Information
After you configure a unicast queue as strict-priority, that particular queue, on the
entire chassis, is treated as a strict-priority queue. Traffic for a strict priority
is scheduled before any other queues are serviced. For example, if you send 100%
Quality of Service (QoS)
1109