Users Guide

show config
Dell(conf-udf-tcam)#show config
!
udf-tcam ipnip seq 1
match l2ethertype ipv4 ipprotocol 4 vlantag any
Dell(conf-udf-tcam)#
9 Create a UDF qualier to assign values to UDF IDs.
CONFIGURATION-UDF TCAM mode
udf-qualifier-value name
Dell(conf-udf-tcam)# udf-qualifier-value ipnip_val1
10 Assign a value to a UDF ID.
CONFIGURATION-UDF-Qualier-Value Prole mode
udf-id 1-12 value mask
Dell(conf-udf-tcam-qual-val)#udf-id 1 aa ff
11 Associate the UDF qualier value with a UDF packet prole in an IP access list.
CONFIGURATION-STANDARD-ACCESS-LIST mode
CONFIGURATION-EXTENDED-ACCESS-LIST mode
permit ip {source mask | any | host ip-address} {destination mask | any | host ip-address}
udf-pkt-format name udf-qualifier-value name
Dell(config-ext-nacl)#permit ip any any udf-pkt-format ipinip udf-qualifier-value ipnip_val1
12 View the UDF TCAM conguration.
CONFIGURATION-UDF TCAM mode
show config
Dell(config-ext-nacl)#show config
!
ip access-list extended aa
seq 5 permit ip any any udf-pkt-format ipnip udf-qualifier-value ipnip_val1
Dell(config-ext-nacl)#
Conguring IP Mirror Access Group
To congure an IP mirror access group on an interface, use the following commands:
1 Allocate CAM prole for IPv4 ACL.
CONFIGURATION mode
cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos number l2qos number
l2pt number ipmacacl number [vman-qos | vman-qos—dual— number | vman-qos—dual—fp number]
ipv4pbr number} ecfmacl number [nlbclusteraclnumber]fcoeacl number iscsioptacl number
ipv4udfmirracl number}
2 Create a monitor session.
CONFIGURATION mode
monitor session session-ID [type { rpm | erpm [set ip dscp dscp_value | set ip ttl
ttl_value]}] [drop]
Dell(conf)#monitor session 65535 type erpm
3 Create an IP access-list.
Access Control Lists (ACLs)
135