Users Guide
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S55, S60, and S4810
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version 6.2.1.0 Introduced on the E-Series.
Usage Information This command is found on the Management interface only.
When manually conguring the management port speed the user must consider and match the remote device. It is
highly recommended to use Auto-Negotiation for management ports.
Related Commands
• interface ManagementEthernet — congure the Management port on the system (either the Primary or
Standby RPM).
• management route — congure a static route that points to the Management interface or a forwarding router.
stack-unit portmode
Syntax
stack-unit stack-unit port number portmode quad
Parameters
stack-unit Enter the stack member unit identier of the stack member to reset.
number Enter the port number of the port to be split.
port Enter the keyword port then the port number to specify the port where fanout mode is
specied.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Interfaces 725