Users Guide

Traffic Class
TLV
Pkts
DCBX Commands
The following DCBX commands are supported on the Dell Networking OS.
advertise dcbx-tlv
On a DCBX port with a manual role, congure the PFC and ETS TLVs advertised to DCBX peers.
Syntax
advertise dcbx-tlv {ets-conf | ets-reco | pfc} [ets-conf | ets-reco | pfc]
[ets-conf | ets-reco | pfc]
To remove the advertised ETS TLVs, use the no advertise dcbx-tlv command.
Parameters
{ets-conf | ets-reco
| pfc}
Enter the PFC and ETS TLVs advertised, where:
• ets-conf: enables the advertisement of ETS conguration TLVs.
• ets-reco: enables the advertisement of ETS recommend TLVs.
• pfc: enables the advertisement of PFC TLVs.
Defaults All PFC and ETS TLVs are advertised.
Command Modes PROTOCOL LLDP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
You can congure the transmission of more than one TLV type at a time; for example: advertise dcbx-tlv
ets-conf ets-reco.
You can enable ETS recommend TLVs (ets-reco) only if you enable ETS conguration TLVs (ets-conf). To
disable TLV transmission, use the no form of the command; for example, no advertise dcbx-tlv pfc
ets-reco
.
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
494 Data Center Bridging (DCB)