Users Guide

Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
Example
Dell(conf-udf-tcam)#show config
!
udf-tcam ipnip seq 1
key innerL3header udf-id 6 packetbase innerL3Header offset 0 length 2
match l2ethertype ipv4 ipprotocol 4 vlantag any
!
udf-qualifier-value ipnip_val1
Dell(conf-udf-tcam)#
udf-id
Assign value for each congured UDF ID in the given UDF TCAM prole.
Syntax
udf-id id value mask
To return to the default settings, use the no udf-id 1-12 value mask command.
Parameters
id Enter the UDF ID range. The range is from 1 to 12.
value Enter the value for the UDF in Hex, up to 24 bytes.
mask Enter the mask for the UDF in Hex, up to 24 bytes.
Defaults None
Command Modes CONFIGURATION-UDF-Qualier-Value Prole
Example
Dell(conf-udf-tcam-qual-val)#udf-id 1 aa ff
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S6000, Z9500.
Related Commands
udf-qualier-value — creates a UDF qualier value.
udf-tcam — creates a context for UDF TCAM.
show cong — displays the current UDF -Qualier-Value Prole conguration.
Access Control Lists (ACL) 275