Users Guide

Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to
16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Example
Dell# show route-map
route-map firpo, permit, sequence 10
Match clauses:
Set clauses:
tag 34
Dell#
Related Commands
• route-map — congure a route map.
UDF ACL Commands
The following commands are available within each UDF ACL mode.
deny ip
Disassociate the UDF in IP access-list.
Syntax
deny ip {source mask | any | host ip-address} {destination mask | any | host
ip-address} udf-pkt-format name udf-qualifier-value name
To remove this lter, use the no seq sequence-number command.
Parameters
source Enter the IP address of the network or host from which the packets were sent.
270 Access Control Lists (ACL)