Users Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000 and Z9000.
9.3(0.1) Introduced on the S6000 and Z9000.
Usage Information
You can congure up to eight allow-remote entries on any multipoint receive-only tunnel.
This command fails if the address family entered does not match the outer header address family of the tunnel
mode, tunnel source, or any other tunnel allow-remote.
If you congure any allow-remote , the tunnel source or tunnel mode commands fail if the outer header address
family does not match that of the congured allow-remote.
Usage Information
Allow-remote entries can be congured only on multipoint receive-only tunnels, that is tunnel mode includes
decapsulate-any option. This command will fail if any bidirectional tunnel options are congured. Likewise, attempts
to congure bidirectional tunnel options will fail if any allow-remote entries are congured.
tunnel destination
Set a destination endpoint for the tunnel.
Syntax
tunnel destination {ip-address | ipv6–address}
To delete a tunnel destination address, use the no tunnel destination {ip-address | ipv6–
address} command.
Parameters
ip-address Enter the destination IPv4 address for the tunnel.
ipv6–address Enter the destination IPv6 address for the tunnel.
Defaults none
Command Modes INTERFACE TUNNEL (conf-if-tu)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
Tunneling 1603