Users Guide

stack-unit stack-group
Congure the stacking unit and stacking group by specifying an ID when adding units to a stack to ensure the unit is assigned to the
correct group.
Syntax
stack-unit unit-id stack-group stack-group-id
To remove the current stack group conguration, use the no stack-unit unit-id stack-group
stack-id command.
Parameters
unit-id Enter the stack unit ID.
stack-group-id Enter the stack group ID. The range is from 0 to 31.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.1 Introduced on the S4810.
8.3.12.0 Reset command mode from EXEC to CONFIGURATION.
Usage Information The following message displays to conrm the command.
Setting ports Fo 1/60 as stack group will make their interface configs
obsolete after a reload.[confirm yes/no]: If “y” is entered, all non-default
configurations on any member ports of the current stack group will be removed
when the unit is rebooted.
NOTE: Any scripts used to streamline the stacking conguration process must be updated to reect the
Command Mode change from EXEC Privilege to CONFIGURATION to allow the scripts to work
correctly.
upgrade system stack-unit
Copy the boot image or Dell Networking OS from the management unit to one or more stack members.
Syntax
upgrade {boot | system} stack-unit {all | stack-unit-number | A | B}
Parameters
boot Enter the keyword boot to copy the boot image from the management unit to the
designated stack members.
1528 Stacking