Reference Guide

enable optic-info-update interval
Enable polling intervals of optical information updates for simple network management protocol (SNMP).
S6000
Syntax
enable optical-info-update interval seconds
To disable optical power information updates, use the no enable optical-
info-update interval command.
Parameters
interval
seconds
Enter the keyword interval then the polling interval in
seconds. The range is from 120 to 6000 seconds. The
default is 300 seconds (5 minutes).
Defaults Disabled
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Replacement command for the S4820T. Replaces the
enable xfp-power-updates command.
Version 8.3.11.4 Replacement command for the Z9000. Replaces the enable
xfp-power-updates command
Version
8.3.10.0
Replacement command for the S4810 only. Replaces the
enable xfp-power-updates command.
Usage
Information
To enable polling and to configure the polling frequency, use this command.
end
Return to EXEC Privilege mode from other command modes (for example, CONFIGURATION or ROUTER
OSPF modes).
S6000
Syntax
end
Command
Modes
• CONFIGURATION
86
Control and Monitoring