Reference Guide

Virtual Router Redundancy Protocol (VRRP) | 883
Sample Configurations
The following configurations are examples for enabling VRRP. These are not comprehensive directions.
They are intended to give you a some guidance with typical configurations.
You can copy and paste from these examples to your CLI. Be sure you make the necessary changes to
support your own IP Addresses, Interfaces, Names, etc.
Figure 51-17 is a sample configuration for enabling VRRP. Figure 51-18 illustrates the topology created
with that CLI configuration.
Task Command Syntax Command Mode
Set the delay time for VRRP initialization on an
individual interface. This is the gap between an
interface coming up and being operational, and
VRRP enabling.
vrrp delay minimum seconds
Seconds range: 0-900
Default: 0
INTERFACE
Set the delay time for VRRP initialization on all
the interfaces in the system configured for
VRRP. This is the gap between system boot up
completion and VRRP enabling.
vrrp delay reload seconds
Seconds range: 0-900
Default: 0
INTERFACE