Reference Guide

780 | Simple Network Management Protocol (SNMP)
www.dell.com | support.dell.com
Copy Configuration Files Using SNMP
Use SNMP from a remote client to:
copy the running-config file to the startup-config file, or
copy configuration files from the Dell Networking system to a server
copy configuration files from a server to the Dell Networking system
The relevant MIBs for these functions are:
%ECFM-5-ECFM_MAC_STATUS_ALARM: MAC Status Defect detected by MEP 1 in Domain
provider at Level 4 VLAN 3000
%ECFM-5-ECFM_REMOTE_ALARM: Remote CCM Defect detected by MEP 3 in Domain
customer1 at Level 7 VLAN 1000
%ECFM-5-ECFM_RDI_ALARM: RDI Defect detected by MEP 3 in Domain customer1 at
Level 7 VLAN 1000
RMON %RPM0-P:CP %SNMP-4-RMON_RISING_THRESHOLD: RMON rising threshold alarm from SNMP
OID <oid>
%RPM0-P:CP %SNMP-4-RMON_FALLING_THRESHOLD: RMON falling threshold alarm from
SNMP OID <oid>
%RPM0-P:CP %SNMP-4-RMON_HC_RISING_THRESHOLD: RMON high-capacity rising threshold
alarm from SNMP OID <oid>
Table 44-3. MIB Objects for Copying Configuration Files via SNMP
MIB Object OID Object Values Description
copySrcFileType .1.3.6.1.4.1.6027.3.5.1.1.1.2 1 = FTOS file
2 = running-config
3 = startup-config
Specifies the type of file to copy from.
Valid values are:
If the copySrcFileType is
running-config or startup-config, the
default copySrcFileLocation is flash.
If the copySrcFileType is a binary file,
the copySrcFileLocation and
copySrcFileName must also be
specified.
copySrcFileLocation .1.3.6.1.4.1.6027.3.5.1.1.1.3 1 = flash
2 = usbflash
3 = tftp
4 = ftp
5 = scp
Specifies the location of source file.
If the copySrcFileLocation is FTP or
SCP, copyServerAddress,
copyUserName, and
copyUserPassword must be specified.
copySrcFileName .1.3.6.1.4.1.6027.3.5.1.1.1.4 Path (if file is not in
current directory)
and filename.
Specifies name of the file.
If copySourceFileType is set to
running-config or startup-config,
copySrcFileName is not required.
Table 44-2. Dell Networking Enterprise-specific SNMP Traps
Command Option Trap