Reference Guide

752 | Service Provider Bridging
www.dell.com | support.dell.com
Display the status and members of a VLAN using the show vlan command from EXEC Privilege mode.
Members of a VLAN-Stacking-enabled VLAN are marked with an M in column Q.
Figure 42-3. Display the Members of a VLAN-Stacking-enabled VLAN
Configure the Protocol Type Value for the Outer VLAN Tag
The Tag Protocol Identifier (TPID) field of the S-Tag is user-configurable:
Display the S-Tag TPID for a VLAN using the command
show running-config from EXEC privilege mode.
FTOS displays the S-Tag TPID only if it is a non-default value.
Task Command Mode Command Syntax
Select a value for the S-Tag TPID.
Default: 9100
CONFIGURATION vlan-stack protocol-type
FTOS#show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
* 1 Active U Te 13/0-5,18
2 Inactive
3 Inactive
4 Inactive
5 Inactive
6 Active M Po1(Te 13/14-15)
M Te 13/13
FTOS#