Reference Guide

IPv6 Routing | 437
Show an IPv6 Interface
View the IPv6 configuration for a specific interface with the following command.
Figure 22-4 shows the
show ipv6 interface command output.
Figure 22-4. Command Example: show ipv6 interface
Command Syntax Command Mode Purpose
show ipv6 interface
type {slot/
port}
EXEC Show the currently running configuration for the
specified interface
Enter the keyword interface followed by the type of
interface and slot/port information:
• For all brief summary of IPv6 status and
configuration, enter the keyword brief.
• For all IPv6 configured interfaces, enter the
keyword configured.
• For a 10/100/1000 Ethernet and Gigabit Ethernet
interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a 10 Gigabit Ethernet interface, enter the
keyword
TenGigabitEthernet followed by the
slot/port information.
• For a 40-Gigabit Ethernet interface, enter the
keyword fortyGigE followed by the slot/port
information.
• For a loopback interface, enter the keyword
loopback followed by the loopback number
• For a port-channel interface, enter the keywords
port-channel followed by the port-channel
number
• For a VLAN interface, enter the keyword vlan
followed by the VLAN ID
• For the Management interface, enter the
keyword ManagementEthernet followed by the
slot/port information.
• For all IPv6 configured interfaces on a particular
stack-unit, enter the keyword stack-unit
stack-unit-id configured