Reference Guide

436 | IPv6 Routing
www.dell.com | support.dell.com
SNMP over IPv6
SNMP is supported on the platforms s z
Simple network management protocol (SNMP) over IPv6 transport so that an IPv6 host can perform
SNMP queries and receive SNMP notifications from a device running FTOS IPv6. The FTOS
SNMP-server commands for IPv6 have been extended to support IPv6. For more information regarding
SNMP commands refer to the
SNMP and SYSLOG chapter in the FTOS Command Line Reference Guide
• snmp-server host
• snmp-server user ipv6
• snmp-server community ipv6
• snmp-server community access-list-name ipv6
• snmp-server group ipv6
• snmp-server group access-list-name ipv6
Show IPv6 Information
All of the following show commands are supported on the platforms s z
View specific IPv6 configuration with the following commands.
IPv6 addresses are normally written as eight groups of four hexadecimal digits, where
each group is separated by a colon (:). Omitting zeros is accepted as described in
Addressing earlier in this chapter.
Command Syntax
Command
Mode Purpose
show ipv6 ?
EXEC or
EXEC Privileged
List the IPv6 show
options.
FTOS#show ipv6 ?
accounting IPv6 accounting information
cam IPv6 CAM Entries for Line Card
fib IPv6 FIB Entries for Line Card
interface IPv6 interface information
management-route Management port route entries
mbgproutes MBGP routing table
neighbors IPv6 neighbor information
prefix-list List IPv6 prefix lists
protocol-queue-mapping IPv6 Protocol queue mapping
route IPv6 routing information
FTOS#
Command Syntax Command Mode Purpose