Reference Guide

Interfaces | 385
Create a single-range
Figure 20-16. Creating a Single-Range Bulk Configuration
Create a multiple-range
Figure 20-17. Creating a Multiple-Range Prompt
Exclude duplicate entries
Duplicate single interfaces and port ranges are excluded from the resulting interface range prompt:
Figure 20-18. Interface Range Prompt Excluding Duplicate Entries
Exclude a smaller port range
If interface range has multiple port ranges, the smaller port range is excluded from prompt:
Figure 20-19. Interface Range Prompt Excluding a Smaller Port Range
Overlap port ranges
If overlapping port ranges are specified, the port range is extended to the smallest start port number and
largest end port number:
Figure 20-20. Interface Range Prompt Including Overlapping Port Ranges
FTOS(config)# interface range Tengigabitethernet 5/1 - 23
FTOS(config-if-range-te-5/1-23)# no shutdown
FTOS(config-if-range-gi-5/1-23)#
FTOS(conf)#interface range tengigabitethernet 3/0 , Tengigabitethernet 2/1 - 47 , vlan 1000
FTOS(conf-if-range-te-2/1-47)#
FTOS(conf)#interface range vlan 1 , vlan 1 , vlan 3 , vlan 3
FTOS(conf-if-range-vl-1,vl-3)#
FTOS(conf)#interface range Tengigabitethernet 2/0 - 23
FTOS(conf-if-range-te-2/0-23)#
FTOS(conf)#interface range Tengigabitethernet 2/0 - 23 , Tengigab 2/1 - 10
FTOS(conf-if-range-te-2/0-23)#
FTOS(conf)#inte ra te 2/1 - 11 , te 2/1 - 23
FTOS(conf-if-range-te-2/1-23)#