Reference Guide

Interfaces | 365
Figure 20-1. show interfaces Command Example
Use the show ip interfaces brief command in the EXEC Privilege mode to view which interfaces are
enabled for Layer 3 data transmission. In Figure 20-2, TenGigabitEthernet interface 1/5 is in Layer 3 mode
since an IP address has been assigned to it and the interface’s status is operationally up.
Figure 20-2. show ip interfaces brief Command Example (Partial)
Use the show interfaces configured command in the EXEC Privilege mode to view only configured
interfaces.
To determine which physical interfaces are available, use the
show running-config command in EXEC
mode. This command displays all physical interfaces available on the line cards. Figure 20-3
FTOS#show interfaces tengigabitethernet 1/0
TenGigabitEthernet 1/0 is up, line protocol is up
Hardware is Dell NetworkingEth, address is 00:01:e8:a0:bf:ed
Current address is 00:01:e8:a0:bf:ed
Pluggable media present, QSFP type is 40GBASE-SR4
Wavelength is 850nm
QSFP receive power reading is -2.1304dBm
Interface index is 38863874
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 10000 Mbit
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:27:28
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 00:24:33
FTOS#show ip interface brief
Interface IP-Address OK? Method Status Protocol
tengigabitEthernet 1/0 unassigned NO Manual administratively down down
tengigabitEthernet 1/1 unassigned NO Manual administratively down down
tengigabitEthernet 1/2 unassigned YES Manual up up
tengigabitEthernet 1/3 unassigned YES Manual up up
tengigabitEthernet 1/4 unassigned YES Manual up up
tengigabitEthernet 1/5 10.10.10.1 YES Manual up up
tengigabitEthernet 1/6 unassigned NO Manual administratively down down
tengigabitEthernet 1/7 unassigned NO Manual administratively down down
tengigabitEthernet 1/8 unassigned NO Manual administratively down down