Reference Guide

Equal Cost Multi-Path (ECMP) | 267
Use the ip ecmp-group path-fallback command to enable or disable the feature.
pt-s4801-temp1(conf)#ip ecmp-group maximum-paths 3
User configuration has been changed. Save the configuration and reload to take effect
pt-s4801-temp1(conf)#
Task Command Command Mode
Configure the maximum number of paths
per ECMP group
ip ecmp-group maximum-paths
{2-64}
CONFIGURATION
Enable ECMP group path management ip ecmp-group path-fallback CONFIGURATION
Note: You must save the new ECMP settings to the startup-config (write-mem) then reload the system for the
new settings to take effect.