Reference Guide

6 | Configuration Fundamentals
www.dell.com | support.dell.com
Table 2-1. FTOS Command Modes
CLI Command Mode Prompt Access Command
EXEC FTOS> Access the router through the console or Telnet.
EXEC Privilege FTOS# • From EXEC mode, enter the command enable.
• From any other mode, use the command end.
CONFIGURATION FTOS(conf)# • From EXEC privilege mode, enter the command
configure.
• From every mode except EXEC and EXEC
Privilege, enter the command exit.
Note: Access all of the following modes from CONFIGURATION mode.
ARCHIVE FTOS(conf-archive) archive
AS-PATH ACL FTOS(config-as-path)# ip as-path access-list
INTERFACE modes
Tengigabit Ethernet
Interface
FTOS(conf-if-te-0/0)# interface
10 Tengigabit
Ethernet Interface
FTOS(conf-if-te-0/0)#
Interface Range FTOS(conf-if-range)#
Loopback Interface FTOS(conf-if-lo-0)#
Management Ethernet
Interface
FTOS(conf-if-ma-0/0)#
Null Interface FTOS(conf-if-nu-0)#
Port-channel Interface FTOS(conf-if-po-0)#
VLAN Interface FTOS(conf-if-vl-0)#
IP ACCESS-LIST
STANDARD
ACCESS- LIST
FTOS(config-std-nacl)# ip access-list standard
EXTENDED
ACCESS- LIST
FTOS(config-ext-nacl)# ip access-list extended
IP
COMMUNITY-LIST
FTOS(config-community-list)# ip community-list
LINE
AUXILIARY FTOS(config-line-aux)# line
CONSOLE FTOS(config-line-console)#
VIRTUAL
TERMINAL
FTOS(config-line-vty)#