Reference Guide

Content Addressable Memory (CAM) | 205
To configure the IPv4 and IPv6 ACLs and Qos regions on the entire system:
Step Task Command Syntax Command Mode
1 Select a cam-acl action
cam-acl [default | l2acl] CONFIGURATION
Note: Selecting default resets the CAM entries to the default settings. Select l2acl to allocate space for
the ACLs, and QoS regions.
2 Enter the number of FP blocks for each
region.
l2acl number ipv4acl number ipv6acl
number, ipv4qos number l2qos
number, l2pt number ipmacacl
number ecfmacl number [vman-qos |
vman-dual-qos number
CONFIGURATION
3 To view the new settings, save the
running-config
write memory EXEC Privilege
4 For example:
S6000-2_FTOS(conf)#do show run | g cam
cam-acl l2acl 4 ipv4acl 4 ipv6acl 2 ipv4qos 1 l2qos 2 l2pt 0 ipmacacl 0 vman-qos 0 ecfmacl 0
fcoeacl 0 iscsioptacl 0
FTOS(conf)#cam-acl l2acl 2 ipv4acl 2 ipv6acl 0 ipv4qos 8 l2qos 1 l2pt 0 ipmacacl 0 vman-qos 0
ecfmacl 0 fcoeacl 0 iscsioptacl 0
FTOS(conf)#do show running-config | grep cam
cam-acl l2acl 2 ipv4acl 2 ipv6acl 0 ipv4qos 8 l2qos 1 l2pt 0 ipmacacl 0 vman-qos 0 ecfmacl 0
fcoeacl 0 iscsioptacl 0
FTOS(conf)#do write
!
Dec 2 01:03:25: %STKUNIT0-M:CP %FILEMGR-5-FILESAVED: Copied running-config to startup-config in
flash by default
FTOS(conf)#
FTOS(conf)#do show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes) Next Boot(in block sizes)
1 block = 256 entries
L2Acl : 2 2
Ipv4Acl : 2 2
Ipv6Acl : 0 0
Ipv4Qos : 2 8
L2Qos : 1 1
L2PT : 0 0
IpMacAcl : 0 0
VmanQos : 0 0
EcfmAcl : 0 0
5 Verify that the new settings will be written
to the CAM on the next boot.
show cam-acl
EXEC Privilege
6 Reload the system.
reload
EXEC Privilege