Reference Guide

202 | Bare Metal Provisioning 2.0 (BMP 2.0)
www.dell.com | support.dell.com
• If there is no version mismatch the system downloads the configuration file.
00:03:27: %STKUNIT0-M:CP %JUMPSTART-5-CFG_APPLY: The downloaded config from dhcp server
is being applied
00:03:27: %STKUNIT0-M:CP %BMP-5-JUMPSTART: DHCP RELEASE sent on Fo 0/56.
00:03:27: %STKUNIT0-M:CP %SYS-5-CONFIG_LOAD: Loading configuration file
c If the configuration file is downloaded from the server, any saved startup-configuration on the
flash is ignored. If no configuration file is downloaded from the server, the startup-configuration
file on the flash is loaded as in normal reload.
6. When the FTOS image and the configuration file have been downloaded, the IP address is released.
00:04:06: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART: DHCP RELEASE sent on Fo 0/56.
00:04:06: %STKUNIT0-M:CP %IFMGR-5-ASTATE_DN: Changed interface Admin state to down: Fo
0/56
7. The system applies the configuration. The system is now up and running. It can be managed as usual.
Configure the system to boot in Normal mode (NOT using Jumpstart) by entering the reload-type normal-reload
command.