Reference Guide

Access Control Lists (ACLs) | 81
Figure 6-11. Command Example: seq
Note the last line in the prefix list Juba contains a “permit all” statement. By including this line in a prefix
list, you specify that all routes not matching any criteria in the prefix list are forwarded.
To delete a filter, use the
no seq sequence-number command in the PREFIX LIST mode.
If you are creating a standard prefix list with only one or two filters, you can let FTOS assign a sequence
number based on the order in which the filters are configured. The FTOS assigns filters in multiples of
five.
To configure a filter without a specified sequence number, use these commands in the following sequence
starting in the CONFIGURATION mode:
Figure 6-12 illustrates a prefix list in which the sequence numbers were assigned by the software. The
filters were assigned sequence numbers based on the order in which they were configured (for example,
the first filter was given the lowest sequence number). The
show config command in the PREFIX LIST
mode displays the two filters with the sequence numbers 5 and 10.
Figure 6-12. Prefix List
Step Command Syntax Command Mode Purpose
1 ip prefix-list prefix-name CONFIGURATION Create a prefix list and assign it a unique name.
2
{deny | permit} ip-prefix [ge
min-prefix-length] [le
max-prefix-length]
CONFIG-NPREFIXL Create a prefix list filter with a deny or permit
action. The optional parameters are:
• ge min-prefix-length: is the minimum
prefix length to be matched (0 to 32).
• le max-prefix-length: is the maximum
prefix length to be matched (0 to 32).
FTOS(conf-nprefixl)#seq 20 permit 0.0.0.0/0 le 32
FTOS(conf-nprefixl)#seq 12 deny 134.23.0.0 /16
FTOS(conf-nprefixl)#seq 15 deny 120.23.14.0 /8 le 16
FTOS(conf-nprefixl)#show config
!
ip prefix-list juba
seq 12 deny 134.23.0.0/16
seq 15 deny 120.0.0.0/8 le 16
seq 20 permit 0.0.0.0/0 le 32
FTOS(conf-nprefixl)#
FTOS(conf-nprefixl)#permit 123.23.0.0 /16
FTOS(conf-nprefixl)#deny 133.24.56.0 /8
FTOS(conf-nprefixl)#show conf
!
ip prefix-list awe
seq 5 permit 123.23.0.0/16
seq 10 deny 133.0.0.0/8
FTOS(conf-nprefixl)#