Administrator Guide

• When a non-supported profile release is upgraded to a supported profile release, the fan-out configured ports get automatically
included in the profile. In fan-out mode, if a system is upgraded with 25 or 26 ports, only 24 ports get upgraded to fan-out mode. The
rest of the ports are put to default 40G mode.
• In stacking, configure profile first before provisioning for new units. Otherwise it is mandatory to reload for profile to take effect.
• If there is a mismatch in fan-out profile between master and the new member in stacking, the master re-configures the member with
its quad-mode profile, quad-mode, and stack-group configuration and then reset the member. To avoid stack split during profile
mismatch, the master does stack group configurations of the new member.
To configure the quad-port-profile, use the following command:
CONFIGURATION mode
stack-unit stack-unit number slot slot-number port port-number portmode quad
The defaults ports are:
0,8,16,24,32,36,40,44,48,52,56,60,64,68,72,76,80,84,88,92,100,108,116,124
To display the Fan-out capability profile, use the following show command:
show system stack-unit stack-unit number quad-port-profile
Example of the
show Command
The following example shows the show system stack-unit stack-unit number quad-port-
profile command.
Dell#show system stack-unit 0 quad-port-profile
Configured fan out profile ports in stack-unit 0
Configured Activated
0 0
8 8
16 16
24 24
32 32
36 36
40 40
44 44
48 48
52 52
56 56
60 60
64 64
68 68
72 72
76 76
80 80
84 84
88 88
92 92
100 100
108 108
116 116
124 124
Dell#
S6010-ON_1#show system stack-unit 1 quad-port-profile
Configured fan out profile ports in stack-unit 1
Configured Activated
2 2
4 4
6 6
8 8
9 9
10 10
11 11
12 12
13 13
14 14
15 15
374
Interfaces