Administrator Guide

The internal Priority assigned for the packet by Ingress FP is used by the memory management unit (MMU) to assign the packet to right
queue by indexing the internal-priority to queue map table (TABLE 1) in hardware.
PRIO2COS setting for honoring the PFC protocol packets from the Peer switches is as per above Packet-Dot1p->queue table (Table 2).
The packets come in with packet-dot1p 2 alone are assign to PG6 on ingress.
The packets come in with packet-dot1p 2 alone use Q1 (as per dot1p to Queue classification – Table 2) on the egress port.
• When Peer sends a PFC message for Priority 2, based on above PRIO2COS table (TABLE 2), Queue 1 is halted.
• Queue 1 starts buffering the packets with Dot1p 2. This causes PG6 buffer counter to increase on the ingress, since P-dot1p 2 is
mapped to PG6.
• As the PG6 watermark threshold is reached, PFC generates for dot1p 2.
Configuration Example for DSCP and PFC
Priorities
Consider a scenario in which the following DSCP and PFC priorities are necessary:
DSCP 0 – 5, 10 - 15 20 – 25, 30 – 35
Expected PFC
Priority
1 2
To configure the aforementioned DSCP and PFC priority values, perform the following tasks:
1. Create class-maps to group the DSCP subsets
class-map match-any dscp-pfc-1
match ip dscp 0-5,10-15
!
class-map match-any dscp-pfc-2
match ip dscp 20-25,30-35
2. Associate above class-maps to Queues Queue assignment as below.
Table 19. Queue Assignments
Internal-priority Queue
0 0
1 0
2 0
3 1
4 2
5 3
6 3
7 3
3. Dot1p->Queue Mapping Configuration is retained at the default value.
Default dot1p-queue mapping is,
DellEMC#show qos dot1p-queue-mapping
Dot1p Priority : 0 1 2 3 4 5 6 7
Queue : 2 0 1 3 4 5 6 7
4. Interface Configurations on server connected ports.
a. Enable DCB globally.
DellEMC(conf)#dcb enable
Data Center Bridging (DCB)
245