Users Guide

NOTE: TDR is an intrusive test. Do not run TDR on a link that is up and passing traffic.
To test and display TDR results, use the following commands.
1 To test for cable faults on the TenGigabitEthernet cable.
EXEC Privilege mode
tdr-cable-test tengigabitethernet slot/port/subport
Between two ports, do not start the test on both ends of the cable.
Enable the interface before starting the test.
Enable the port to run the test or the test prints an error message.
2 Displays TDR test results.
EXEC Privilege mode
show tdr tengigabitethernet slot/port/subport
Splitting 40G Ports without Reload
You can split 40G interfaces into 10G ports without reboot. You can also combine the split ports to create a 40G port without
reload.
• On a device, fan-out profile constructs automatically with default 24 ports
(2,4,6,8,9,10,11,12,13,14,15,16,17,18,19,20,21,22,23,24,25,27,29,31) . These ports can be changed to 40G to 10G mode or
vice-versa without reload.
• When a non-supported profile release is upgraded to a supported profile release, the fan-out configured ports get
automatically included in the profile. In fan-out mode, if a system is upgraded with 25 or 26 ports, only 24 ports get
upgraded to fan-out mode. The rest of the ports put to default 40G mode.
• In stacking, configure profile first before provisioning for new units. Otherwise it is mandatory to reload for profile to take
effect.
• If there is a mismatch in fan-out profile between master and the new member in stacking, the master re-configures the
member with its quad-mode profile, quad-mode, and stack-group configuration and then reset the member. To avoid
stack split during profile mismatch, the master does stack group configurations of the new member.
To configure the quad-port-profile, use the following command:
CONFIGURATION mode
stack-unit [stack-unit number] quad-port-profile [default | list of ports]
The defaults ports are:
2,4,6,8,9,10,11,12,13,14,15,16,17,18,19,20,21,22,23,24,25,27,29,31
Example:
stack-unit stack-unit-number quad-port-profile [default | list of ports]
To display the Fan-out capability profile, use the following show command:
show system stack-unit quad-port-profile
Example of the
show Command
The following example shows the system stack-unit quad-port-profile command.
Dell(conf)#stack-unit 1 port 24 portmode quad
Warning: Enabling quad mode on stack-unit 1 port 24. Please verify whether the
configs related to interface Fo 1/24 are cleaned up before proceeding further.
[confirm yes/no]:yes
Dell(conf)#00:02:24: %STKUNIT1-M:CP %IFMGR-5-DYNAMIC_FANOUT: Port 24 in slot 1
Interfaces 367