Deployment Guide
Table Of Contents
- 1 Introduction
- 2 Hardware overview
- 3 Topology options
- 4 VxRail in the data center
- 5 Configuration planning
- 6 Switch configuration prerequisites
- 7 Configure switches
- 8 Switch validation
- 9 Deploy VxRail
- 10 Use of VxRail 4.7.0 to validate Dell EMC Networking S5200F-ON
- A Validated components for S5148F-ON using VxRail 4.5
- B Validated components for S5248F-ON and S5232F-ON using VxRail 4.7.0
- C VxRail network adapter traffic optimization
- D Configure breakouts on port groups and interfaces
- E Technical resources
- F Support and feedback
9 Dell EMC Networking OS10 Enterprise Edition Switch Configuration Guide for VxRail featuring S5248F-ON,
S5232F-ON and S5148F-ON
2 Hardware overview
This section briefly describes the hardware used to validate this deployment. Appendix A and Appendix B
contain a complete listing of hardware and software validated for this guide.
2.1 Dell EMC Networking S5248F-ON
The S5248F-ON is a 1-Rack Unit (RU), multilayer switch with 48x25GbE, 4x100GbE, and 2x200GbE ports.
This guide uses two S5248F-ONs as leaf switches.
Dell EMC Networking S5248F-ON
2.2 Dell EMC Networking S5232F-ON
The S5232F-ON is a 1-RU, multilayer switch with 32x100GbE and 2x10GbE ports. This guide uses two
S5232F-ONs as leaf switches.
Dell EMC Networking S5232F-ON
2.3 Dell EMC Networking S5148F-ON
The S5148F-ON is a 1-RU, multilayer switch with 48x25GbE, and 6x100GbE or 72x25GbE ports. This guide
uses two S5148F-ONs as leaf switches.
Dell EMC Networking S5148F-ON
2.4 Dell EMC Networking S3048-ON
The S3048-ON is a 1-RU switch with 48x1GbE BASE-T ports and 4x10GbE SFP+ ports. This guide uses one
S3048-ON switch for out-of-band (OOB) management traffic.
Dell EMC Networking S3048-ON