Users Guide

Configure switches
33 Dell EMC Networking OS9 Switch Configuration Guide for VxRail 4.5
S5048F-ON
no shutdown
interface twentyFiveGigE 1/22
description Node3_Port2
no ip address
portmode hybrid
switchport
spanning-tree rstp edge-port
flowcontrol rx on tx off
no shutdown
interface twentyFiveGigE 1/23
description Node4_Port1
no ip address
portmode hybrid
switchport
spanning-tree rstp edge-port
flowcontrol rx on tx off
no shutdown
interface twentyFiveGigE 1/24
description Node4_Port2
no ip address
portmode hybrid
switchport
spanning-tree rstp edge-port
flowcontrol rx on tx off
no shutdown
7.3.3 Configure VLANs
In this section, VLANs are configured per Table 2.
Assign an IP address to the in-band management VLAN. Add the interfaces connected to the nodes and jump
box as untagged members of the in-band management VLAN.
Note: In this example, the jump box also provides DNS and NTP services as covered in Section 5.4
. If these
services are located on other devices, ensure the switch interfaces connected to these services are also
added to the in-band management VLAN.
Add the VxRail node interfaces as tagged members of the vMotion, vSAN, and VM Network VLANs.
When the configuration is complete, exit configuration mode and save the configuration with the end and
write memory commands.