White Papers

15 bytes successfully copied

DellEMC#copy flash://test/capture.txt.pcap nfsmount:///

Destination file name [test.txt]:

15 bytes successfully copied

DellEMC#copy flash://test/capture.txt.pcap nfsmount:///username/snoop.pcap

24 bytes successfully copied

DellEMC#

DellEMC#copy tftp://10.16.127.35/username/dv-maa-test ?

flash: Copy to local file system ([flash://]filepath)

nfsmount: Copy to nfs mount file system (nfsmount:///filepath)

running-config remote host:

Destination file name [test.c]:

225 bytes successfully copied

DellEMC#

Saving the Running-Conguration

The running-conguration contains the current system conguration. Dell Networking recommends coping your running-conguration to

the startup-conguration.

The system uses the startup-conguration during boot-up to congure the system. The startup-conguration is stored in the internal ash

on the IOM by default, but you can save the startup-conguration to a USB ash device or on a remote server.

NOTE: The commands in this section follow the same format as those in Copying Files to and from the System but use the

lenames startup-conguration and running-conguration. These commands assume that current directory is the internal ash,

which is the system default.

• Save the running-conguration to the startup-conguration on the internal ash.

EXEC Privilege mode

copy running-config startup-config

• Save the running-conguration to the usb ash on the IOM.

EXEC Privilege mode

copy running-config usbflash://filename

• Save the running-conguration to an FTP server.

EXEC Privilege mode

copy running-config ftp:// username:password@{hostip | hostname}/filepath/ filename

• Save the running-conguration to a TFTP server.

EXEC Privilege mode

copy running-config tftp://{hostip | hostname}/filepath/ filename

• Save the running-conguration to an SCP server.

EXEC Privilege mode

copy running-config scp:// username:password@{hostip | hostname}/filepath/ filename

NOTE

: When copying to a server, you can only use a hostname if you congured a DNS

server.

Viewing Files

You can only view le information and content on local le systems.

To view a list of les or the contents of a le, use the following commands.

• View a list of les on the internal ash.

EXEC Privilege mode

Getting Started